MFD 800 / MFD 900

Ultimo 2000
A powerful remote pulser receiver for ultrasonic applications with unique features.
The low impedance and 5 Volt rf output make the unit suitable for remote applications with a very long cable between the pulser receiver and main system.
The bandwidth is 40 MHz at 80 dB true gain and the high energy square wave pulser can be controlled from 40 to 400 volt.  The pulser can also be switched to a spike output.

New remote pulser receiver system RPR50

This new 50 MHz system has been developed for applications requiring a compact  pulser receiver close to the transducer. Especially for C-scan systems, robotic applications and other remote situations the RPR50 set is ideal. The performance is absolutely great and outperforms systems like USIP20HR. The system comprises a compect remote pulser/pre-amplifier of just 200 grams, a control module at up to 20 meters of cable and a PC interface card with control software
Call us for full specifications.
   

Highspeed Automotive Cilinder Scanner

The Cylinder scanner checks the bonding between the lining of the cylinder and the  aluminum of the block. It is designed for manual placement after wich the computer takes over. A fast scan and a good readable C-scan is the result.

The system was originally developed for VAW in Germany and has been in use with good results since 1999.  Demonstrations were given at a major NDT show in Rome in 2000 with lots of interest from various manufacturers.

In-production testsystem for bar materiaal from 10 to 80 mm diameter.

together with a few Allied engineers partners we have developed a highly advanced and efficient testsystem to test bar stock products ( brass in this occasion) for internal flaws and inclusions which are introduced during the manufacturing process.
The material is fully immersed in water at the place of measurement where 8 to 16 ultrasonic transducers inspect the material for 100%. Flat bottom holes of 1.2 mm ( #3 fbh) are easily detected

Please contact us for detailed information

A simple to install barfollower . The follower section has 2 rollers mount on a free moving follower unit which always keeps the rollers on the bar, even with seriously bent bars. The ultrasonic transducer is placed in the middle of the rollers and can be easily normalized in two directions and adjusted in height.
Sensors indicate end of bar in both directions.

Allied Enginneers have developed a compact high power ultrasonic pulser module and low noise pre-amplfier which can be used for remote pulser receiver applications where long transducer cables are required or where extra amplfication is required.
The pulser can be triggered from the excisting puls output of any type flawdetector. The module gives a powerful square wave puls of maximum 450 Volt with a very high capacity capable to drive large elements.  The square wave can be adjusted for transducer of 4 to 12 MHz, which is mostly used in industrial applications. 
The pre-amplfier has a low noise gain selectable of 6,12 or 18 dB

Power supply 12 VDC
We can supply the printed circuit boards only or built in a small box

Off line bar tester.
A rugged and efficient bar tester for bars from 40 to 500 mm diameter.
Equiped with a multiprobe barfollower

FT3000 distance thickness meter
The FT3000 uses low frequency ultrasound to measure the distance from the sensor to a product . By testing from both sides one can measure the thickness of a product without contact.
Automatic compensation for changes in the sound velocity in air due to temperature and other influences. A typical accuracy is 0.1 mm but this is strongly influenced by the testing range required.  Applications are found in wood-,  foam- and plexiglass industrie but also for specific projects where laser test systems cannot be applied.